Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

DTC    C1551    IG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU distinguishes the power switch status as on (IG) or off through the IG power source circuit.

DTC No.
DTC Detection Condition
Trouble Area
C1551
Open or short in IG power source circuit with power switch on (IG)
  1. ECU-IG No. 2 fuse
  2. IG power source circuit
  3. Power steering ECU

WIRING DIAGRAM


C113532E18


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU has been replaced with a new one, perform the assist map writing and the torque sensor zero point calibration (Click here).

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING TECHSTREAM (IG POWER SUPPLY)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "IG power supply" in the Data List and read the value displayed on the Techstream.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG power supply
    IG power supply/
    Min.: 0 V
    Max.: 20.1531 V
    11 to 14 V
    Power switch on (IG)

    OK:
    The normal condition value is displayed on the Techstream.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS 

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)
  1. Disconnect the connectors from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    L54-6 (IG) - A27-2 (PGND)
    Power switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)