Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

DTC    C1552    PIG Power Supply Voltage Malfunction

DTC    C1554    Power Supply Relay Failure

for Preparation Click here


DESCRIPTION

When a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1552
PIG power source circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU
C1554
Power source relay circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU

WIRING DIAGRAM


C160852E23


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU has been replaced with a new one, perform the assist map writing and the torque sensor zero point calibration (Click here).

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING TECHSTREAM
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (READY).

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "PIG power supply" in the Data List and read the value displayed on the Techstream.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PIG Power Supply
    Power source voltage to activate motor/
    Min.: 0 V
    Max.: 20.1531 V
    11 to 14 V
    Power switch on (READY)

    OK:
    The normal condition value is displayed on the Techstream.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS 

2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - POWER STEERING ECU - BODY GROUND)


    C113534E20
  1. Disconnect the connector from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A27-1 (PIG) - Body ground
    Power switch on (READY)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-2 (PGND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Power Steering ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)