CAN COMMUNICATION SYSTEM > Main Body ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Main Body ECU Communication Stop Mode |
|
|

| 1.CHECK CAN BUS WIRE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE) |
Turn the power switch off.
![]() |
Disconnect the main body ECU connector.
| *1 | Front view of wire harness connector (to Main Body ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L7-14 (CANH) - L7-13 (CANL) | Power switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
![]() |
Disconnect the instrument panel junction block connector.
| *1 | Component without harness connected (Instrument Panel Junction Block) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2C-18 (BECU) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2B-6 (GND1) - Body ground | Always | Below 1 Ω |
| *1 | Component without harness connected (Instrument Panel Junction Block) |
|
| ||||
| OK | ||
| ||