FRONT DRIVE SHAFT ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING |
Install a new front drive shaft hole snap ring to the front drive inboard joint assembly.
| 2. INSTALL FRONT DRIVE SHAFT ASSEMBLY |
![]() |
Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly.
![]() |
Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.
| *1 | Matchmark |
| 3. CONNECT FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY |
![]() |
Install the front No. 1 lower suspension arm sub-assembly to the front lower ball joint with the bolt and 2 nuts.
| 4. CONNECT FRONT STABILIZER LINK ASSEMBLY |
![]() |
Install the front stabilizer link assembly to the front shock absorber with coil spring with the nut.
| 5. CONNECT TIE ROD END SUB-ASSEMBLY |
![]() |
Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.
Install a new clip.
| 6. INSTALL FRONT FLEXIBLE HOSE |
![]() |
Install the front flexible hose to the steering knuckle with the bolt.
| 7. CONNECT FRONT SPEED SENSOR |
![]() |
Install the front speed sensor and front flexible hose to the front shock absorber with the bolt and clamp.
![]() |
Install the front speed sensor to the steering knuckle with the bolt.
| 8. INSTALL FRONT AXLE SHAFT NUT |
Clean the threaded parts on the drive shaft and a new axle shaft nut using a non-residue solvent.
![]() |
Using a socket wrench (30 mm), install the axle shaft nut.
Using a chisel and hammer, stake the front axle shaft nut.
| 9. ADD HYBRID TRANSAXLE FLUID |
![]() |
Add transaxle fluid until the fluid level is between 0 to 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening.
| *1 | Filler Plug |
| *2 | Filler Nozzle |
After adding fluid, leave it for 30 seconds so that the fluid surface can become still again, and then check that the fluid level is between 0 to 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening. (If the fluid is insufficient, return to the Add Hybrid Transaxle Fluid procedure.)
Using a 10 mm hexagon socket wrench, install the filler plug with a new gasket.
| 10. INSPECT HYBRID TRANSAXLE FLUID |
![]() |
Using a 10 mm hexagon socket wrench, remove the filler plug and gasket.
| *1 | Filler Plug |
Check that the fluid level is between 0 to 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening. (If the fluid is insufficient, return to the Add Hybrid Transaxle Fluid procedure.)
Check for leaks if the quantity of transaxle fluid is low.
Using a 10 mm hexagon socket wrench, install the filler plug with a new gasket.
| 11. INSTALL FRONT WHEELS |
| 12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
| 13. INSTALL REAR ENGINE UNDER COVER LH |
| 14. INSTALL REAR ENGINE UNDER COVER RH |
| 15. INSTALL NO. 1 ENGINE UNDER COVER |
| 16. INSPECT SPEED SENSOR SIGNAL |