CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Skid Control ECU Communication Stop Mode |
|
|

| 1.CHECK DTC (BRAKE SYSTEM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
|
| ||||
| OK | |
| 2.CHECK CAN BUS WIRE FOR DISCONNECTION (SKID CONTROL ECU BRANCH WIRE) |
Turn the power switch off.
![]() |
Disconnect the skid control ECU (brake booster with master cylinder) connector.
| *1 | Front view of wire harness connector (to Skid Control ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A58-37 (CA1H) - A58-38 (CA1L) | Power switch off | 54 to 69 Ω |
|
| ||||
| OK | ||
| ||