Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

DTC    C1515    Torque Sensor Zero Point Adjustment Undone

for Preparation Click here


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that the torque sensor zero point calibration has not been performed.

DTC No.
DTC Detection Condition
Trouble Area
C1515
Torque sensor zero point calibration not performed
There is no malfunction if DTC is not output after performing the torque sensor zero point calibration.

INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (Click here).
  2. If the electric power steering column sub-assembly has been replaced with a new one, perform torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (Click here).

1.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
  1. Perform the torque sensor zero point calibration (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is still output even after performing torque sensor zero point calibration 3 times*1.
    A
    DTC is still output even after performing torque sensor zero point calibration once or twice*2.
    B
    Normal system code is output.
    C

    HINT:
    1. *1: The power steering ECU assembly must be replaced if DTC C1515 is still output even after the torque sensor zero point calibration is performed 3 times.
    2. *2: Perform torque sensor zero point calibration again if DTC C1515 is still output even after the calibration is performed once or twice.



B
PERFORM ZERO POINT CALIBRATION AGAIN (TORQUE SENSOR) (Click here)

C
END
A


3.REPLACE POWER STEERING ECU ASSEMBLY
  1. Replace the power steering ECU assembly (Click here).


NEXT


Go to step 2

4.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
  1. Perform the torque sensor zero point calibration (Click here).


NEXT


5.CHECK FOR DTC
  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is still output even after performing torque sensor zero point calibration 3 times*1.
    A
    DTC is still output even after performing torque sensor zero point calibration twice*2.
    B
    Normal system code is output.
    C

    HINT:
    1. *1: The electric power steering column sub-assembly must be replaced if DTC C1515 is still output even after the torque sensor zero point calibration is performed 3 times.
    2. *2: Perform torque sensor zero point calibration again if DTC C1515 is still output even after the calibration is performed twice.



B
PERFORM ZERO POINT CALIBRATION AGAIN (TORQUE SENSOR) (Click here)

C
END
A

REPLACE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY (Click here)