FRONT SEAT CUSHION HEATER (for Power Seat) > INSTALLATION |
| 1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY (SEPARATE TYPE FRONT SEAT CUSHION COVER) |
![]() |
Using hog ring pliers, install the front seat cushion heater assembly (separate type front seat cushion cover) to the separate type front seat cushion pad with 11 new hog rings.
![]() |
Using hog ring pliers, install 2 new hog rings.
| 2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD |
Engage each hook to install the separate type front seat cushion cover with pad to the front seat cushion spring sub-assembly as shown in the illustration.

![]() |
Engage the 2 hooks as shown in the illustration.
![]() |
Engage the fastener to connect the side airbag wire harness.
Connect the connector and engage the clamp to connect the seat heater wire harness.
![]() |
Engage the 3 clamps to connect the seat heater wire harness.
![]() |
Engage the 4 hooks.
![]() |
Connect the rubber band.
| 3. INSTALL FRONT INNER SEAT CUSHION SHIELD |
![]() |
Engage the 5 claws to install the front inner seat cushion shield.
| 4. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY |
![]() |
Connect the 2 connectors.
Engage the clamp.
![]() |
Engage the guide and 5 claws.
Engage the clip to install the front seat cushion shield assembly.
![]() |
Engage the 6 clamps.
Connect the 4 connectors.
| 5. INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD |
![]() |
Engage the 2 claws and clip.
Engage the guide to install the front inner No. 1 seat cushion shield to the front seat cushion shield with the screw.
| 6. INSTALL FRONT SEAT INNER BELT ASSEMBLY |
![]() |
Install the front seat inner belt assembly with the nut.
| *1 | Protruding Part |
Connect each connector.
Engage each clamp.
| 7. INSTALL FRONT SEAT ASSEMBLY |