SMART KEY SYSTEM (for Entry Function) > Back Door Entry Unlock Function does not Operate |

| 1.READ VALUE USING TECHSTREAM (ENTRY BACK DOOR OPEN FUNCTION) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| B-Dr Opening Operation | Back door opening Operation / Long, Twice, OFF | Customization status displayed | - |
| Result | Proceed to |
| Customize setting is Long or Twice. | A |
| Customize setting is OFF. | B |
|
| ||||
| A | |
| 2.CHECK POWER DOOR LOCK OPERATION |
When the door control switch on the master switch assembly is operated, check that the doors unlock and lock according to switch operation (Click here).
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM |
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Trunk and Back-Door Open | Operate back door lock motor | ON or OFF | - |
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (BACK DOOR OPENER SWITCH) |
Enter the following menus: Body Electrical / Smart Key / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Tr/B-Door Unlock SW | Back door opener switch assembly (opener switch) / ON or OFF | ON: Back door opener switch assembly (opener switch) pushed OFF: Back door opener switch assembly (opener switch) not pushed | - |
|
| ||||
| OK | ||
| ||
| 5.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY |
![]() |
Remove the back door opener switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 2 (E) - 3 (UL) | Back door opener switch assembly (opener switch) not pushed (OFF) | 10 kΩ or higher |
| 2 (E) - 3 (UL) | Back door opener switch assembly (opener switch) pushed (ON) | Below 1 Ω |
| *1 | Component without harness connected (Back Door Opener Switch Assembly) |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BACK DOOR OPENER SWITCH) |
![]() |
Disconnect the certification ECU (smart key ECU Assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-22 (TSW5) - V4-3 (UL) | Always | Below 1 Ω |
| L62-22 (TSW5) - Body ground | Always | 10 kΩ or higher |
| V4-3 (UL) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
| *2 | Front view of wire harness connector (to Back Door Opener Switch Assembly) |
|
| ||||
| OK | ||
| ||