Home › Drivetrain › P410 HYBRID TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > REMOVAL

for Preparation Click here


NOTICE:
If the shift lock control unit assembly is to be replaced with a new one, it is necessary to clear the learned shift sensor voltage value by disconnecting and reconnecting the cable of the negative (-) battery terminal (Click here).



1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



2. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



3. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. REMOVE SHIFT LEVER KNOB


    A306889
  1. Apply protective tape around the shift lock control unit assembly.

    NOTICE:
    As adhesive residue may fall when removing the shift lever knob, apply protective tape.



    A306890
  1. Turn the shift lever knob in the direction of the arrow in the illustration to remove it.



6. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    B223452E01
  1. Using a moulding remover, slightly lift the panel at the position shown in the illustration.
    Text in Illustration 
    *a
    Lift slightly

  1. Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.

  1. Disconnect each connector and remove the integration control and panel assembly.



7. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B223454
  1. Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.



    B223455
  1. Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.



8. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY


    C209262
  1. Disconnect the connector from the shift lock control unit assembly.

  1. Remove the 3 nuts and shift lock control unit assembly.