Home › Engine / Hybrid System › 2ZR-FXE LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Put the engine in inspection mode (Click here).

  1. Warm up and stop the engine, then wait for 5 minutes. The oil level should be between the low level and full level marks on the engine oil level dipstick. If the engine oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill with engine oil to above the full level mark.

    HINT:
    A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
    1. When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.
    2. If low quality oil or oil of an inappropriate viscosity is used.
    3. When driving at high engine speed or with a heavy load, (when towing , or), when driving while accelerating or decelerating frequently.
    4. When leaving the idling for a long time, or when driving frequently through heavy traffic.
    When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.



2. CHECK ENGINE OIL
  1. Check the engine oil for deterioration, water contamination, discoloring or thinning. If the condition is visibly poor, replace the engine oil and oil filter element.



3. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Remove the oil pressure switch (Click here).



    A154775
  1. Install the oil pressure gauge with the adapter.

  1. Put the engine in inspection mode (Click here).

  1. Warm up the engine.

  1. Check the oil pressure.

    Standard Oil Pressure:
    Engine Condition
    Oil Pressure
    Idle
    60 kPa (0.6 kgf/cm2, 8.7 psi) or more
    2500 rpm
    142 kPa (1.4 kgf/cm2, 21 psi) or more

  1. If the oil pressure is not as specified, check the oil pump (Click here).

  1. Install the oil pressure switch (Click here).