Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brushless Type Motor)

DTC    C1515    Torque Sensor Zero Point Adjustment Undone

DTC    C1525    Rotation Angle Sensor Initialization Undone

for Preparation Click here


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly stores these DTCs when it determines that rotation angle sensor initialization and torque sensor zero point calibration have not been performed.

DTC No.
DTC Detection Condition
Trouble Area
C1515
This DTC is stored when torque sensor zero point calibration has not been performed.
There is no malfunction if this DTC is not output again after performing zero point calibration.
C1525
This DTC is stored when rotation angle sensor initialization has not been performed.
There is no malfunction if this DTC is not output again after performing rotation angle sensor initialization.

INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly has been replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).
  2. If the electric power steering column sub-assembly or power steering motor assembly has been replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC
  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (step 1) (Click here).

  1. Check for DTCs (step 2) (Click here).

HINT:
If DTCs are output, perform steps 1 and 2 two more times.

Result:
Result
Proceed to
DTCs are still output after performing rotation angle sensor initialization and steering zero point calibration 3 times.
A
Normal system code is output.
B



B
END
A


2.REPLACE POWER STEERING ECU ASSEMBLY
  1. Replace the power steering ECU assembly (Click here).


NEXT


3.CHECK FOR DTC
  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (step 1) (Click here).

  1. Check for DTCs (step 2) (Click here).

HINT:
If DTCs are output, perform steps 1 and 2 two more times.

Result:
Result
Proceed to
C1515 is still output after performing rotation angle sensor initialization and steering zero point calibration 3 times.
A
C1525 is still output after performing rotation angle sensor initialization and steering zero point calibration 3 times.
B
Normal system code is output.
C



B
REPLACE POWER STEERING MOTOR ASSEMBLY

C
END
A

REPLACE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY