Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brushless Type Motor)

DTC    C1528    Motor Rotation Angle Sensor Malfunction

for Preparation Click here


DESCRIPTION

The motor rotation angle sensor detects the motor rotation angle and sends this information to the power steering ECU assembly.

DTC No.
DTC Detection Condition
Trouble Area
C1528
Motor rotation angle sensor malfunction
  1. Motor rotation angle sensor (built into power steering motor assembly)
  2. Power steering ECU assembly

WIRING DIAGRAM


C137251E25


INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly has been replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).
  2. If the electric power steering column sub-assembly or power steering motor assembly has been replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK CONNECTOR CONNECTION CONDITION
  1. Check the installation condition of the motor rotation angle sensor connector.

    OK:
    Motor rotation angle sensor connector is securely connected to the power steering ECU assembly.



NG
CONNECT CONNECTOR
OK


2.READ VALUE USING TECHSTREAM (MOTOR ROTATION ANGLE SENSOR)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (READY).

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "Motor Rotation Angle" in the Data List and read the value displayed on the Techstream.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Motor Rotation Angle
    Motor rotation angle/
    Min.: 0 deg
    Max.: 1441.77 deg
    During steering operation, motor rotation angle value changes from 0 to 360°
    Power switch on (READY) and power steering in operation

    OK:
    During steering operation, motor rotation angle value changes from 0 to 360°.



NG
Go to step 3
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)  

3.CHECK POWER STEERING MOTOR ASSEMBLY


    C181647E08
  1. Disconnect the connector from the motor rotation angle sensor.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z15-6 (RZSN) - z15-3 (RZG)
    Always
    75.2 to 112.8 Ω
    z15-1 (RZV) - z15-3 (RZG)
    Always
    27.6 to 41.4 Ω
    z15-5 (RZCS) - z15-3 (RZG)
    Always
    73.2 to 110.8 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Motor Rotation Angle Sensor)



NG
REPLACE POWER STEERING MOTOR ASSEMBLY (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)