Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brushless Type Motor)

DTC    C1516    Torque Sensor Zero Point Adjustment Incomplete

DTC    C1526    Rotation Angle Sensor Initialization Incomplete

for Preparation Click here


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly outputs these DTCs when it determines that rotation angle sensor initialization and torque sensor zero point calibration are incomplete.

DTC No.
DTC Detection Condition
Trouble Area
C1516
Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration.
There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration and performing zero point calibration.
C1526
Rotation angle sensor initialization is incomplete due to the steering wheel being touched during calibration.
There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration and performing rotation angle sensor initialization.

INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly has been replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).
  2. If the electric power steering column sub-assembly or power steering motor assembly has been replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC
  1. Clear the DTCs (step 1) (Click here).

  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (step 2) (Click here).

  1. Check for DTCs (step 3) (Click here).

    HINT:
    If DTCs are output, perform steps 1 to 3 two more times.

    Result:
    Result
    Proceed to
    DTCs are still output after performing rotation angle sensor initialization and steering zero point calibration 3 times.
    A
    Normal system code is output.
    B



B
END
A


2.REPLACE POWER STEERING ECU ASSEMBLY
  1. Replace the power steering ECU assembly (Click here).


NEXT


3.CHECK FOR DTC
  1. Clear the DTCs (step 1) (Click here).

  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (step 2) (Click here).

  1. Check for DTCs (step 3) (Click here).

    HINT:
    If DTCs are output, perform steps 1 to 3 two more times.

    Result:
    Result
    Proceed to
    C1516 is still output after performing rotation angle sensor initialization and steering zero point calibration 3 times.
    A
    C1526 is still output after performing rotation angle sensor initialization and steering zero point calibration 3 times.
    B
    Normal system code is output.
    C



B
REPLACE POWER STEERING MOTOR ASSEMBLY

C
END
A

REPLACE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY