DTC B1242 Wireless Door Lock Tuner Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1242 |
|
|

| 1.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - CERTIFICATION ECU AND BODY GROUND) |
![]() |
Disconnect the L62 and L63 certification ECU (smart key ECU assembly) connectors.
Disconnect the S12 door control receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L63-16 (RSSI) - S12-2 (RSSI) | Always | Below 1 Ω |
| L63-15 (RDA) - S12-5 (DATA) | Always | Below 1 Ω |
| L63-5 (RC0) - S12-4 (+5) | Always | Below 1 Ω |
| L62-15 (E) - Body ground | Always | Below 1 Ω |
| S12-1 (GND) - Body ground | Always | Below 1 Ω |
| L63-16 (RSSI) or S12-2 (RSSI) - Body ground | Always | 10 kΩ or higher |
| L63-15 (RDA) or S12-5 (DATA) - Body ground | Always | 10 kΩ or higher |
| L63-5 (RC0) or S12-4 (+5) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
| *2 | Front view of wire harness connector (to Door Control Receiver) |
|
| ||||
| OK | |
| 2.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
![]() |
Reconnect the L62 and L63 certification ECU (smart key ECU assembly) connectors and the S12 door control receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L63-5 (RC0) - L62-15 (E) | Power switch off, all doors closed and transmitter switch pressed | 4.5 to 5.5 V |
| *1 | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | |
| 3.REPLACE DOOR CONTROL RECEIVER |
Temporarily replace the door control receiver with a new one (Click here).
| NEXT | |
| 4.CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||