Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > DCM POWER SOURCE CIRCUIT

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the DCM (Telematics Transceiver).

WIRING DIAGRAM


E196655E41


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (DCM (TELEMATICS TRANSCEIVER) - AUXILIARY BATTERY AND BODY GROUND)


    E192516E54
  1. Disconnect the L144 DCM (Telematics Transceiver) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L144-4 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L144-1 (+B) - L144-4 (E)
    Power switch off
    11 to 14 V
    L144-7 (IG2) - L144-4 (E)
    Power switch on (IG)
    11 to 14 V
    L144-8 (ACC) - L144-4 (E)
    Power switch on (ACC)
    11 to 14 V

Text in Illustration 
*1
Front view of wire harness connector
(to DCM (Telematics Transceiver))


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)