Voice Guidance
Symptom
| Suspected Area
| See page
|
"Safety Connect failure detected, please contact your dealer" message is played.
| Refer to HEALTH CHECK.
|
Click here
|
Diagnostic Trouble Code Chart. (Red indicator has failed and cannot indicate a failure.)
|
Click here
|
"Safety Connect Activation Failed" message is played.
| Wait for some time, then move to different location and retry (try to find location with better signal reception)
| -
|
Refer to HEALTH CHECK.
|
Click here
|
Diagnostic Trouble Code Chart.
|
Click here
|
Contact Telematics Service Provider to verify any network problems
| -
|
"Unable to Connect the Emergency Call Center" or "Unable to Connect to the Call Center" message is played.
| Wait for a while, then move to a different location and retry (try to find a location with better signal reception).
| -
|
Perform Vehicle Inquiry on Techstream and verify subscription status.
| -
|
Refer to UNABLE TO CONNECT TO CALL CENTER.
|
Click here
|
"Safety Connect is not active" message is played.
| Perform Vehicle Inquiry on Techstream and verify subscription status.
| -
|
Explain to the customer that the system is in deactive mode, and confirm whether or not they would like to change to active mode.
| -
|
Indicator Condition
Symptom
| Suspected Area
| See page
|
Green indicator abnormal (Remains OFF)
| Refer to DCM POWER SOURCE CIRCUIT
|
Click here
|
Refer to GREEN INDICATOR REMAINS OFF
|
Click here
|
Red indicator abnormal (Remains ON)
| Refer to RED INDICATOR REMAINS ON
|
Click here
|
Green and red indicators abnormal (Remains OFF)
| Refer to GREEN AND RED INDICATORS DO NOT COME ON WHEN IG-ON
|
Click here
|
Refer to DCM POWER SOURCE CIRCUIT
|
Click here
|
DCM (Telematics Transceiver)
|
Click here
|
Green and red indicators blink simultaneously
| Refer to GREEN AND RED INDICATORS BLINK SIMULTANEOUSLY
|
Click here
|