Home › Engine / Hybrid System › 2ZR-FXE INTAKE / EXHAUST › INTAKE MANIFOLD

INTAKE MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE THROTTLE BODY ASSEMBLY
(Click here)


2. REMOVE EGR PIPE ASSEMBLY


    A212663
  1. Disconnect the 2 wire harness clamps.



    A212664
  1. Remove the bolt and wire harness support.



    A212665
  1. Remove the 4 bolts, EGR pipe assembly and 2 gaskets.



3. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    A212672
  1. Disconnect the connector.

  1. Remove the bolt and manifold absolute pressure sensor.



4. REMOVE VACUUM SWITCHING VALVE ASSEMBLY


    A219372
  1. Disconnect the connector and 2 fuel vapor feed hoses.



    A219373
  1. Remove the bolt and vacuum switching valve assembly.



5. REMOVE INTAKE MANIFOLD


    A212682
  1. Disconnect the 3 connectors and 2 wire harness clamps.

  1. Remove the engine oil level dipstick.



    A212681
  1. Disconnect the wire harness clamp, and then remove the 2 bolts and engine oil level dipstick guide sub-assembly.

  1. Remove the O-ring from the engine oil level dipstick guide sub-assembly.



    A212683
  1. Disconnect the fuel vapor feed hose and ventilation hose.



    A212684
  1. Remove the 2 bolts, 2 nuts and intake manifold.

  1. Remove the No. 1 intake manifold to head gasket from the intake manifold.



  1. w/ Stud Bolt:



      A212685
    1. Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.

      HINT:
      If a stud bolt is deformed or the threads are damaged, replace the stud bolt.