Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A01    Driving Support ECU

for Preparation Click here


DESCRIPTION

The driving support ECU uses the lane-recognition camera sensor assembly to detect obstacles in front of the vehicle and the direction that the driver's head is facing.

DTC No.
DTC Detection Condition
Trouble Area
C1A01
While initial check is running, power switch is on (IG) and system is operating, driving support ECU detects an internal malfunction for 1 second or more
Driving support ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTC (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle and operate lane keeping assist control.

  1. Recheck for DTCs (Click here).

    OK:
    DTC C1A01 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)