Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A06    Stop Light Switch Input Circuit

for Preparation Click here


DESCRIPTION

This DTC indicates the internal abnormal items of the driving support ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1A06
Stop light switch assembly input signal abnormal
(driving support ECU internal circuit)
Driving support ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle and operate lane keeping assist control.

  1. Recheck for DTCs (Click here).

    OK:
    DTC C1A06 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)