Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

LANE-KEEPING ASSIST SYSTEM > Indicator Circuit

for Preparation Click here


DESCRIPTION

  1. When the driving support ECU detects a lane-keeping assist main switch signal, it sends the signal to the combination meter via CAN communication. Then the LKA indicator light turns on.
  2. The LKA indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (LKA INDICATOR LIGHT)
  1. Select the Active Test, use the Techstream to generate a control command, and then check that the LKA indicator light illuminates.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Drift From The Lane
    LKA indicator light
    ON / OFF
    -

    OK:
    LKA indicator light turns on / turns off.



NG
REPLACE NO. 3 METER CIRCUIT PLATE (Click here)
OK


2.READ VALUE USING TECHSTREAM (LKA INDICATOR LIGHT)
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Data List / LKA Indicator.

  1. Check the Data List for proper functioning of the LKA indicator light.

    Lane Keeping Assist 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    LKA Indicator
    LKA indicator light signal / Nothing, Blink, Light
    Light: LKA indicator light turns on
    Nothing: LKA indicator light turns off
    Blink: LKA indicator light blinking
    -

    OK:
    LKA indicator light turns on / turns off.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)