DTC C1A01 Driving Support ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A01 | While power switch is on (IG) and dynamic radar cruise control system is operating, driving support ECU detects an internal malfunction for 1 sec. | Driving support ECU |
| 1.READ OUTPUT DTC |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A01 is output | B |
|
| ||||
| A | ||
| ||