NAVIGATION SYSTEM (for Navigation Receiver Type) > Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver |

| 1.INSPECT DCM (TELEMATICS TRANSCEIVER) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L144-17 (MUTE) - Body ground | Power switch on (ACC), audio system is playing → Emergency call mode | Above 3.5 V → Below 1 V |
| *a | Component with harness connected (DCM (Telematics Transceiver)) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - DCM (TELEMATICS TRANSCEIVER)) |
Disconnect the stereo component amplifier assembly connector.
Disconnect the DCM (telematics transceiver) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L143-24 (TMUT) - L144-17 (MUTE) | Always | Below 1 Ω |
| L143-24 (TMUT) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY |
Reconnect the stereo component amplifier assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L144-17 (MUTE) - Body ground | Power switch on (ACC) | Above 3.5 V |
| *a | Front view of wire harness connector (to DCM (Telematics Transceiver)) |
|
| ||||
| OK | ||
| ||