DTC C1A03 Driving Support ECU Internal Logical Error |
DTC C1A06 Stop Light Switch Input Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A03 | Cruise control input signal abnormal | Driving support ECU |
| C1A06 | Stop light switch input signal abnormal | Driving support ECU |
| 1.READ OUTPUT DTC |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control main switch on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC C1A03 or C1A06 is output | B |
|
| ||||
| A | ||
| ||