Home › Engine / Hybrid System › 2ZR-FXE FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A148186E11
  1. Apply gasoline to 2 new O-rings and then install them to the fuel pressure regulator assembly.
    Text in Illustration 
    *1
    O-ring



    A130364E02
  1. Install the fuel pressure regulator assembly.



2. INSTALL FUEL PUMP

HINT:
Perform "Inspection After Repair" after replacing the fuel pump (Click here).



    A288172E01
  1. Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Spacer

  1. Connect the fuel pump harness connector to the fuel pump.

  1. Engage the 5 claws of the fuel pump.

    NOTICE:
    1. Make sure that the O-ring is not cut or pinched during the installation.
    2. Engage the claws securely.
    3. Do not remove the suction filter.

  1. Engage the 2 claws of the No. 1 fuel suction support.

  1. Engage the 2 claws of the fuel suction support and install the fuel filter and the fuel pump onto the fuel sub-tank.



    A217126
  1. Align the groove of the fuel pump filter hose with the cutout of the fuel sub-tank and install the hose.

    NOTICE:
    Do not apply excessive force to the fuel tube or the suction support.

  1. Connect the fuel pump harness connector to the fuel suction plate sub-assembly.



3. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A288160
  1. Install the fuel sender gauge assembly by sliding it downward.

  1. Connect the connector of the fuel sender gauge assembly.

  1. Install the 2 harness protectors to the wire harness.

    NOTICE:
    Do not damage the wire harness.

  1. Connect the 3 harness clamps.

    NOTICE:
    Do not damage the wire harness.



4. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
  1. Install the fuel suction tube assembly with pump and gauge (Click here).