Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (Click here).



    A216695
  1. Install the engine coolant temperature sensor through a new gasket.

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }

  1. Connect the engine coolant temperature sensor connector.



2. INSTALL INVERTER RESERVE TANK ASSEMBLY


    A212304
  1. Install the inverter reserve tank assembly with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



3. INSTALL EGR WITH COOLER PIPE SUB-ASSEMBLY
  1. Install the EGR with cooler pipe sub-assembly (Click here).



4. PERFORM INITIALIZATION
  1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (Click here).