Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > INSTALLATION

for Preparation Click here



1. INSTALL LOWER STEERING WHEEL BOSS COVER


    C206252
  1. Engage the 2 pins and 4 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.



2. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


3. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)


    E186305
  1. Install the cruise control main switch with the 2 screws.



    E186306
  1. Connect the connector.



4. INSTALL STEERING PAD SWITCH ASSEMBLY


    C241120
  1. Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }



    C241121
  1. Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }



5. INSTALL STEERING SHAKE DAMPER


    C206249
  1. Install the steering shake damper to the steering wheel assembly with the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }



6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


7. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B226994
  1. Rotate the spiral cable counterclockwise slowly by hand until it stops.

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.



    B226995E01
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
    Text in Illustration 
    *1
    Alignment Mark

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



8. INSTALL STEERING WHEEL ASSEMBLY


    C248390E01
  1. Align the matchmarks on the steering wheel assembly and steering main shaft.
    Text in Illustration 
    *1
    Matchmark

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect the connectors to the spiral cable sub-assembly.



9. CHECK STEERING WHEEL CENTER POINT


10. INSTALL STEERING PAD

HINT:
Refer to the instructions for Installation of the steering pad (Click here).