POWER WINDOW CONTROL SYSTEM > Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH |

| 1.READ VALUE USING TECHSTREAM (RL-Door Motor) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / RL-Door Motor / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| RL Door P/W Auto SW | Rear LH side power window auto switch signal / ON or OFF | ON: Rear LH power window auto switch operated OFF: Rear LH power window auto switch not operated | - |
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION (for Rear LH Side) |
Initialize the power window regulator motor assembly (for rear LH side) (Click here).
| NEXT | |
| 3.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION) |
Check that the rear LH side door power window moves when the auto up and down function of the power window regulator switch assembly (for rear LH side) is operated (Click here).
|
| ||||
| OK | ||
| ||
| 4.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear LH Side) |
![]() |
Remove the power window regulator switch assembly (for rear LH side) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 8 (AUTO) - 1 (GND) | Auto up or auto down position | Below 1 Ω |
| *1 | Component without harness connected (Power Window Regulator Switch Assembly (for Rear LH Side)) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (REAR LH SIDE SWITCH - REAR LH SIDE MOTOR) |
![]() |
Disconnect the power window regulator motor assembly (for rear LH side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q2-8 (AUTO) - Q4-4 (AUTO) | Always | Below 1 Ω |
| Q2-8 (AUTO) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Power Window Regulator Switch Assembly (for Rear LH Side)) |
| *2 | Front view of wire harness connector (to Power Window Regulator Motor Assembly (for Rear LH Side)) |
|
| ||||
| OK | ||
| ||