Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

DTC    C1553    PIG Power Supply Overvoltage

for Preparation Click here


DESCRIPTION

If the power steering ECU determines that the motor power source voltage and the IG voltage are not within the specified range, it stops the power assist as a fail-safe function.

DTC No.
DTC Detection Condition
Trouble Area
C1553
  1. PIG power source overvoltage
  2. IG power source overvoltage
  1. IG and PIG power source circuits
  2. Power steering ECU

WIRING DIAGRAM


C210563E17


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU has been replaced with a new one, perform the assist map writing and the torque sensor zero point calibration (Click here).

1.CHECK HARNESS AND CONNECTOR (IG, PIG)
  1. Disconnect the connectors from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-1 (PIG) - A27-2 (PGND)
    Always
    11 to 14 V
    L54-6 (IG) - A27-2 (PGND)
    Power switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)