Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise SET Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. The power management control ECU detects a cruise control switch signal and sends it to the combination meter assembly through CAN. Then the SET indicator light comes on.
  2. The SET indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

WIRING DIAGRAM

Refer to "Cruise Main Indicator Light Circuit" .

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the SET indicator light by performing the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. SET
    SET indicator light
    BLINK / OFF
    -

    OK:
    The SET indicator light blinks or goes off according to Techstream operation.



NG
REPLACE NO.3 METER CIRCUIT PLATE (Click here)
OK


2.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Cruise Control / Data List.

  1. According to the display on tester, read the Data List.

    Cruise Control (Power Management Control ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    SET/COAST Switch
    - SET switch / ON or OFF
    ON: - SET switch ON
    OFF: - SET switch off
    -

    OK:
    The display changes as shown above according to cruise control main switch operation.



NG
REPLACE POWER MANAGEMENT CONTROL ECU (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)