Home › Power Source / Network › POWER DISTRIBUTION › POWER MANAGEMENT CONTROL ECU

POWER MANAGEMENT CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL POWER MANAGEMENT CONTROL ECU


    E189829
  1. Engage the 2 claws to install the power management control ECU.



2. INSTALL ECU INTEGRATION BOX


    E189828
  1. Install the ECU integration box with the 2 nuts and bolt.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }

  1. Engage the 3 clamps to connect the wire harness.

  1. Connect each connector.



3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    B223650E01
  1. With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
    Text in Illustration 
    *a
    Opened Approximately 55°
    *b
    Closed

    NOTICE:
    Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.



    B223648E01
  1. Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Stopper

  1. Engage the claw and connect the glove compartment door stopper sub-assembly.



4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Connect each connector.

  1. Engage the guide and 3 claws to install the No. 2 instrument panel under cover sub-assembly.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).