Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > GREEN AND RED INDICATORS DO NOT COME ON WHEN IG-ON

for Preparation Click here


DESCRIPTION

If the red and green indicators fail to illuminate after the power switch on (IG), the vehicle does not recognize the DCM (Telematics Transceiver). The DCM (Telematics Transceiver) connectors may have been disconnected or the DCM (Telematics Transceiver) is malfunctioning.

INSPECTION PROCEDURE

1.HEALTH CHECK
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and wait for 10 seconds.

  1. Turn the Techstream on.

  1. Perform "Health Check" using the Techstream and check that Telematics (Safety Connect) is listed on "Health Check Result" (Click here).

    Result:
    Result
    Proceed to
    "Telematics" is displayed on the Techstream
    A
    "Telematics" is not displayed on the Techstream
    B



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
A


2.CHECK DTC
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and wait for 10 seconds.

  1. Turn the Techstream on.

  1. Check current DTC and history DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)