Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM

DTC    B1350    Speaker Circuit

for Preparation Click here


DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.
This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1350
Either of the following conditions is met:
  1. When sound output voltage is being monitored by the ECU, with the power switch on (IG), battery voltage 10 V or more, and warning sound being produced, a speaker circuit short condition continues for 1 second or more.
  2. When sound output voltage is being monitored by the ECU, with the power switch on (IG) and warning sound not being produced, a speaker circuit open condition continues for 5 seconds or more.
  1. Vehicle approaching speaker controller
  2. Vehicle approaching speaker assembly
  3. Harness or connector between vehicle approaching speaker controller and vehicle approaching speaker assembly

WIRING DIAGRAM


E282277E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER ASSEMBLY)
  1. Disconnect the L140 vehicle approaching speaker controller connector.

  1. Disconnect the A69 vehicle approaching speaker assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L140-3 (SP+) - A69-1 (+)
    Always
    Below 1 Ω
    L140-8 (SP-) - A69-2 (-)
    Always
    Below 1 Ω
    L140-3 (SP+) or A69-1 (+) - Body ground
    Always
    10 kΩ or higher
    L140-8 (SP-) or A69-2 (-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT VEHICLE APPROACHING SPEAKER CONTROLLER
  1. Reconnect the L140 vehicle approaching speaker controller connector.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Active Test.

  1. Check the operation by referring to the table below.

    Vehicle Proximity Notification System 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Proximity Sound (Vehicle Stationary)
    Proximity sound (Vehicle stationary)
    OFF or ON
    Produces warning sound when vehicle is stopped



    E289168E03
  1. Check the signal waveform according to the condition(s) in the table below.
    Item
    Condition
    Tool setting
    1 V/DIV., 200 ms./DIV.
    Vehicle condition
    Vehicle approaching speaker operating
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Vehicle Approaching Speaker Assembly)

    OK:
    The waveform is displayed as shown in the illustration.



NG
REPLACE VEHICLE APPROACHING SPEAKER CONTROLLER (Click here)
OK


3.INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY
  1. Remove the vehicle approaching speaker assembly (Click here).

  1. Inspect the vehicle approaching speaker assembly (Click here).



NG
REPLACE VEHICLE APPROACHING SPEAKER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)