Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)


2. REMOVE FUEL SENDER GAUGE ASSEMBLY


A105590
  1. Disconnect the fuel sender gauge assembly connector.



  1. Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.


    A306881E01


    Text in Illustration 
    *A
    Type A
    *B
    Type B

    NOTICE:
    Make sure that the fuel sender gauge arm does not bend.



3. REMOVE FUEL PUMP WITH FILTER ASSEMBLY


    A105592
  1. Disconnect the connector of the fuel pump harness.



    A109341
  1. Disconnect the suction filter hose.



    A119168E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump with filter assembly from the No. 1 fuel sub-tank.
    Text in Illustration 
    *1
    No. 1 Fuel Sub-tank
    *2
    Fuel Tube

    NOTICE:
    Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter, such as applying excessive force to the tube (Click here).



    A119157
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.



    A268451E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump with filter assembly from the fuel filter.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter

    NOTICE:
    1. Do not damage the fuel filter.
    2. Do not remove the suction filter.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A171289
  1. Disconnect the fuel pump harness connector.



    A192533E06
  1. Remove the O-ring and fuel pump spacer from the fuel pump with filter assembly.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer
    *a
    5.0 mm (0.197 in.)

    NOTICE:
    Be careful not to damage the sealing surface.

    HINT:
    If the O-ring still remains in the fuel filter assembly, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.



4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A126640
  1. Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly.

    NOTICE:
    Slowly pull out the fuel pressure regulator assembly because the O-ring is firmly installed between the fuel pressure regulator assembly and the fuel filter.



    A148186E11
  1. Remove the 2 O-rings from the fuel pressure regulator assembly.
    Text in Illustration 
    *1
    O-ring