Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > REMOVAL

for Preparation Click here




1. REMOVE STEERING WHEEL ASSEMBLY
(Click here)


2. REMOVE LOWER STEERING COLUMN COVER


    C248042
  1. Remove the 3 screws.



    C256915
  1. Disengage the 4 claws and remove the lower steering column cover.



3. REMOVE UPPER STEERING COLUMN COVER


    C248044
  1. Disengage the 2 claws and remove the upper steering column cover.



4. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
  1. Remove the spiral cable with sensor sub-assembly .

    NOTICE:
    1. Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
    2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).
    3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
    4. Do not remove the steering angle sensor from the spiral cable.