DTC B1443/43 Air Outlet Damper Control Servo Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1443/43 | Air outlet damper position sensor value does not change even though the air conditioning amplifier assembly operates the No. 1 air conditioning radiator damper servo sub-assembly (air outlet). |
|

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Operate the MODE switch.
Enter the following menus: Body / Air Conditioner / Data List.
Check the value(s) by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Outlet Servo Actu Pulse (D) | No. 2 air conditioning radiator damper servo sub-assembly (air outlet) actual pulse / Min.: 128, Max.: 383 | FACE: 267 (pulse) B/L: 250 (pulse) FOOT: 227 (pulse) FOOT/DEF: 220 (pulse) DEF: 206 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Air Outlet Servo Pulse (D) | No. 2 air conditioning radiator damper servo sub-assembly (air outlet) pulse | Min.: 128, Max.: 383 | Operates between 206 and 267 pulses |
|
| ||||
| OK | ||
| ||
| 3.REPLACE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (AIR OUTLET) |
Replace the No. 2 air conditioning radiator damper servo sub-assembly (air outlet) (Click here).
Check for the DTC.
| Result | Proceed to |
| DTC B1443/43 is output | A |
| DTC B1443/43 is not output | B |
|
| ||||
| A | |
| 4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY |
Replace the air conditioning harness assembly (Click here).
Check for the DTC.
| Result | Proceed to |
| DTC B1443/43 is output | A |
| DTC B1443/43 is not output | B |
|
| ||||
| A | ||
| ||