DTC P0335 Crankshaft Position Sensor "A" Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 | Either of the following conditions is met (1 trip detection logic):
|
|
![]() |
| ECM Terminal Name | CH1: Between G2+ and G2- CH2: Between NE+ and NE- |
| Tester Range | 5 V/DIV., 20 ms./DIV. |
| Condition | Idling |
| Required Sensors/Components (Main) | Crank position sensor |
| Required Sensors/Components (Related) | Cam position sensor |
| Frequency of Operation | Continuous |
| Crank position sensor |
|
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Put the engine in inspection mode (maintenance mode) (Click here).
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Engine Speed.
Read the values displayed on the tester while the engine is running.
|
| ||||
| OK | ||
| ||
| 2.INSPECT CRANK POSITION SENSOR (RESISTANCE) |
Inspect the crank position sensor (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CRANK POSITION SENSOR - ECM) |
Disconnect the crank position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C11-1 - C10-78 (NE+) | Always | Below 1 Ω |
| C11-2 - C10-110 (NE-) | Always | Below 1 Ω |
| C11-1 or C10-78 (NE+) - Body ground | Always | 10 kΩ or higher |
| C11-2 or C10-110 (NE-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| C11-1 - C9-78 (NE+) | Always | Below 1 Ω |
| C11-2 - C9-110 (NE-) | Always | Below 1 Ω |
| C11-1 or C9-78 (NE+) - Body ground | Always | 10 kΩ or higher |
| C11-2 or C9-110 (NE-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK SENSOR INSTALLATION (CRANK POSITION SENSOR) |
![]() |
Check the crank position sensor installation.
|
| ||||
| OK | |
| 5.INSPECT CRANKSHAFT (TEETH OF CRANK ANGLE SENSOR PLATE) |
Inspect the teeth of the crank angle sensor plate.
|
| ||||
| OK | ||
| ||