STEERING COLUMN ASSEMBLY > REMOVAL |
| 1. PRECAUTION |
| 2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE HORN BUTTON ASSEMBLY |
| 4. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Remove the steering wheel assembly set nut.
| *a | Matchmark |
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable.
![]() |
Using SST, remove the steering wheel assembly.
| *a | Turn |
| *b | Hold |
| 5. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 3 screws.
![]() |
Disengage the 4 claws and remove the lower steering column cover.
| 6. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the 2 claws and remove the upper steering column cover.
| 7. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY |
Disconnect the connectors from the turn signal switch assembly with spiral cable sub-assembly.
![]() |
Using pliers, expand the clamp.
| *1 | Clamp |
| *2 | Claw |
While holding the clamp expanded, raise the claw using a screwdriver to disengage it, and then remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.
| 8. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY |
| 9. REMOVE COLUMN HOLE COVER SILENCER SHEET |
![]() |
Remove the 2 clips and the column hole cover silencer sheet.
| 10. SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY |
![]() |
Put matchmarks on the steering sliding yoke sub-assembly and steering gear assembly.
| *a | Matchmark |
Loosen bolt A.
Remove bolt B.
Separate the steering sliding yoke sub-assembly from the steering gear assembly.
| 11. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY |
![]() |
Put matchmarks on the steering sliding yoke sub-assembly and No. 2 steering intermediate shaft assembly.
| *a | Matchmark |
Remove the steering sliding yoke sub-assembly from the No. 2 steering intermediate shaft assembly.
| 12. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the No. 2 steering intermediate shaft assembly and steering column assembly.
| *a | Matchmark |
Remove the bolt.
Remove the steering intermediate shaft assembly from the steering column assembly.
| 13. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY |
| 14. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY |
| 15. REMOVE STEERING COLUMN ASSEMBLY |
![]() |
Disconnect the 2 connectors from the power steering ECU assembly.
Disengage the wire harness clamp.
Disconnect the connectors and disengage the wire harness clamps from the steering column assembly.
![]() |
Remove the bolt, 2 nuts and steering column assembly.