STEERING PAD > INSTALLATION |
| 1. INSTALL HORN BUTTON ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Connect the airbag connector to the horn button assembly.
| *1 | Airbag Connector |
| *2 | Horn Connector |
| *3 | Airbag Connector Lock |
Push in the airbag connector lock to install the airbag connector.
Connect the horn connector to the horn button assembly.
![]() |
Push the horn button assembly to engage the 2 pins carefully.
| 2. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
Engage the claw and guide to install the lower No. 3 steering wheel cover.
| 3. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
Engage the claw and guide to install the lower No. 2 steering wheel cover.
| 4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 5. INSTALL FRONT FLOOR COVER RH |
| 6. INSPECT HORN BUTTON ASSEMBLY |
Make sure that the horn sounds.
| 7. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 8. INSPECT SRS WARNING LIGHT |