Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


    E234955E01
  1. Install the No. 1 cooler thermistor as shown in the illustration.

    Installation Position:
    Mark
    Measurement
    A
    61.1 mm (2.41 in.)
    B
    47.7 mm (1.88 in.)
    C
    50 mm (1.97 in.)

    Text in Illustration 
    *a
    Secured Part
    *b
    Sensor Part

    NOTICE:
    1. Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
    2. When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
    3. After inserting the thermistor, do not apply excessive force to the wire.
    4. Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".



2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E235039
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the No. 1 cooler evaporator sub-assembly.

    Compressor oil:
    ND-OIL 11 or equivalent

  1. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

    NOTICE:
    Keep the O-rings and O-ring fitting surfaces free of foreign matter.



    E235038
  1. Install the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor to the upper heater case as shown in the illustration.



    E238230
  1. Engage the 4 claws and install the lower heater case.

  1. Engage the clamp and connect the connector to the lower heater case.



  1. for Type A:



      E238229
    1. Install the 4 screws.



  1. for Type B:



      E288000
    1. Install the 6 screws.



3. INSTALL COOLER EXPANSION VALVE


    E238228
  1. Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }



4. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY
(Click here)