FRONT EVAPORATOR TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR) |
![]() |
Install the No. 1 cooler thermistor as shown in the illustration.
| Mark | Measurement |
| A | 61.1 mm (2.41 in.) |
| B | 47.7 mm (1.88 in.) |
| C | 50 mm (1.97 in.) |
| *a | Secured Part |
| *b | Sensor Part |
| 2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the No. 1 cooler evaporator sub-assembly.
Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.
![]() |
Install the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor to the upper heater case as shown in the illustration.
![]() |
Engage the 4 claws and install the lower heater case.
Engage the clamp and connect the connector to the lower heater case.
![]() |
Install the 6 screws.
| 3. INSTALL COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
| 4. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY |