ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Brake Control Warning Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BRAKE WARNING LIGHT / YELLOW (MINOR MALFUNCTION)) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Select the Active Test on the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| ECB* Warning Light | Brake warning light / yellow (minor malfunction) | Warning light ON/OFF | Observe combination meter assembly |
Check that the brake warning light / yellow (minor malfunction) on the combination meter assembly turns on or off in accordance with intelligent tester operation.
| Result | Proceed to |
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.INSPECT COMBINATION METER ASSEMBLY |
Turn the power switch off (lock).
Perform the Active Test of the combination meter assembly (meter CPU) using the intelligent tester (Click here).
Check the combination meter assembly.
| Result | Proceed to |
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||