Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Brake Control Warning Light Remains ON

for Preparation Click here


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication.
If the skid control ECU stores a DTC, the brake warning light / yellow (minor malfunction) comes on in the combination meter assembly.

WIRING DIAGRAM


C239015E09


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
  1. Check if the skid control ECU (brake booster with master cylinder assembly) connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK


3.CHECK AUXILIARY BATTERY
  1. Check the auxiliary battery voltage.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Auxiliary battery
    Power switch on (IG)
    11 to 14 V
    Auxiliary battery
    Power switch on (ready)
    11 to 15.5 V



NG
CHARGE OR REPLACE AUXILIARY BATTERY
OK


4.INSPECT COMBINATION METER ASSEMBLY
  1. Perform the Active Test of the combination meter assembly (meter CPU) using the intelligent tester (Click here).

  1. Check the combination meter assembly.

    OK:
    The brake warning light / yellow (minor malfunction) turns on or off in accordance with intelligent tester operation.


    Result:

    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG
    C

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table refer back to the table and proceed to the next step before replacing the part (Click here).



B
REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (Click here)