DTC C1203/95 ECM Communication Circuit Malfunction |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| C1203/95 | - | Either of the following is detected:
|
|
| 1.CHECK PART NUMBER |
Check that the proper hybrid vehicle control ECU, main body ECU (multiplex network body ECU) and yaw rate and acceleration sensor (airbag sensor assembly) are installed.
Check if the hybrid vehicle control ECU, main body ECU (multiplex network body ECU) and yaw rate and acceleration sensor (airbag sensor assembly) were replaced before the DTC was recorded.
| Result | Proceed to |
| OK | A |
| NG (A proper hybrid vehicle control ECU is not installed and/or the hybrid vehicle control ECU was replaced.) | B |
| NG (A proper main body ECU (multiplex network body ECU) is not installed and/or the main body ECU (multiplex network body ECU) was replaced.) | C |
| NG (A proper yaw rate and acceleration sensor (airbag sensor assembly) is not installed and/or the yaw rate and acceleration sensor (airbag sensor assembly) was replaced.) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE |
Perform initialization and calibration of the linear solenoid valve (Click here).
| NEXT | |
| 3.RECONFIRM DTC |
Turn the power switch off (lock).
Clear the DTCs (Click here).
Turn the power switch on (IG).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1203/95 is output (for LHD). | A |
| DTC C1203/95 is output (for RHD). | B |
| DTC C1203/95 is not output. | C |
|
| ||||
|
| ||||
| A | ||
| ||