Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0571    Brake Switch "A" Circuit

for Preparation Click here


DESCRIPTION

When the brake pedal is depressed, the stop light switch assembly sends a signal to the hybrid vehicle control ECU. When the hybrid vehicle control ECU receives this signal, it cancels the cruise control. The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit. Cruise control cancellation occurs when voltage is applied to terminal STP. When the brake is applied, voltage is normally applied to terminal STP of the hybrid vehicle control ECU through the STOP fuse and the stop light switch assembly, and the hybrid vehicle control ECU turns the cruise control off.

DTC No.
DTC Detection Condition
Trouble Area
P0571
Voltage of STP signal and that of ST1- signal of hybrid vehicle control ECU are less than 1 V for 0.5 seconds or more
  1. Stop light switch assembly
  2. Stop light switch circuit
  3. Hybrid vehicle control ECU

WIRING DIAGRAM


B381571E05


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK WIRE HARNESS AND CONNECTOR (STOP LIGHT SWITCH POWER SOURCE)


    E248380E30
  1. Disconnect the A65 stop light switch assembly connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A65-1 (B)- A65-3 (GND)
    Power switch off
    11 to 14 V
    A65-5 (B)- A65-3 (GND)
    Power switch on (IG)
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A65-3 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Stop Light Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT STOP LIGHT SWITCH ASSEMBLY
  1. Inspect the stop light switch assembly (Click here).



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - STOP LIGHT SWITCH ASSEMBLY)
  1. Disconnect the A38 and A39 hybrid vehicle control ECU connectors.

  1. Disconnect the A65 stop light switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    A38-15 (STP) - A65-2 (OUT)
    Always
    Below 1 Ω
    A39-28 (ST1-) - A65-4 (L)
    Always
    Below 1 Ω

    Standard Resistance (Check for Short):
    Tester Connection
    Condition
    Specified Condition
    A38-15 (STP) or A65-2 (OUT) - Body ground
    Always
    10 kΩ or higher
    A39-28 (ST1-) or A65-4 (L) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (HYBRID VEHICLE CONTROL ECU - STOP LIGHT SWITCH ASSEMBLY)
OK

REPLACE HYBRID CONTROL ECU (Click here)