BRAKE PEDAL STROKE SENSOR (for LHD) > INSTALLATION |
| 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT |
Check the brake pedal height.
Turn back the carpet.
Turn back the dash silencer from the slit provided on the dash silencer.
Measure the shortest distance between the brake pedal surface and floor panel or No. 2 dash panel insulator pad as shown in the illustration.

| *1 | Brake Pedal | - | - |
| *a | Brake Pedal Height | - | - |
![]() | Measuring Plane of Floor Panel or No. 2 Dash Panel Insulator Pad | - | - |
| Condition | Specification |
| from floor panel | 131.2 to 141.2 mm (5.17 to 5.55 in.) |
| from No. 2 dash panel insulator pad | 107.3 to 117.3 mm (4.23 to 4.61 in.) |
Adjust the brake pedal height.
![]() |
Remove the stop light switch assembly .
| *1 | Stop Light Switch Assembly |
| *2 | Clevis Lock Nut |
| *3 | Floor Panel |
| *4 | No. 2 Dash Panel Insulator Pad |
| *a | Brake Pedal Height from Floor Panel |
| *b | Brake Pedal Height from No. 2 Dash Panel Insulator Pad |
Loosen the clevis lock nut.
Adjust the brake pedal height by turning the push rod.
| Condition | Specification |
| from floor panel | 131.2 to 141.2 mm (5.17 to 5.55 in.) |
| from No. 2 dash panel insulator pad | 107.3 to 117.3 mm (4.23 to 4.61 in.) |
Tighten the clevis lock nut.
Install and adjust the stop light switch assembly .
| 2. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY |
When installing a new brake pedal stroke sensor assembly:
![]() |
Install a new brake pedal stroke sensor assembly to the brake pedal support assembly with the 2 bolts.
| *1 | Brake Pedal Stroke Sensor Assembly Lever |
| *a | Brake Pedal Groove |
Connect the connector.
Firmly depress the brake pedal and break the brake pedal stroke sensor assembly lever set pin.
Remove the broken lever set pin.
When reusing the brake pedal stroke sensor assembly:
![]() |
Install the brake pedal stroke sensor assembly to the brake pedal support assembly and temporarily tighten the 2 bolts.
| *1 | Brake Pedal Stroke Sensor Assembly Lever |
| *a | Brake Pedal Groove |
Connect the connector.
| 3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. ADJUST BRAKE PEDAL STROKE SENSOR ASSEMBLY |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List "Stroke Sensor".
![]() |
Read the stroke sensor value in the Data List, and turn the brake pedal stroke sensor assembly slowly to the right or left to adjust the output voltage so that it is within the following range.
![]() |
Tighten the 2 bolts.
Turn the intelligent tester off and turn the power switch off.
Disconnect the intelligent tester.
| 5. CHECK AND CLEAR DTC |
| 6. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE |