FRONT LOWER SUSPENSION ARM > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
![]() |
Remove the clip and nut.
![]() |
Install SST to the threaded section of the lower ball joint.
Using SST, separate the front lower No. 1 suspension arm sub-assembly LH from the steering knuckle.

| *a | Apply grease | *b | Place wrench here |
| 3. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts and front lower No. 1 suspension arm sub-assembly LH from the front suspension crossmember sub-assembly.
| 4. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH |