Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR SUSPENSION SUPPORT ASSEMBLY
  1. Install the rear suspension support assembly to the rear shock absorber assembly.



2. INSTALL REAR SUSPENSION SUPPORT STOPPER
  1. Install the rear suspension support stopper to the rear shock absorber assembly.



3. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
  1. Insert the upper end of the rear shock absorber assembly to the vehicle body.

  1. Support the spring seat of the rear axle beam assembly using a jack and wooden block.

  1. Jack up the rear axle beam assembly slowly, and provisionally install the rear shock absorber assembly (lower side) with the bolt and nut onto the rear axle beam assembly.

    NOTICE:
    Since a stopper nut is used, turn the bolt.

    HINT:
    Insert the bolt with the threaded end facing the outside of the vehicle.

  1. Install the rear suspension support and rear shock absorber cushion retainer.



    C106033E02
  1. While holding the piston rod, install a new nut (lower nut) to the specified standard.

    Standard (A):
    15 to 18 mm (0.591 to 0.709 in.)

  1. Install a new nut (upper nut) onto the lower nut.



    C338970
  1. Hold the lower nut and tighten the upper nut against it.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }



4. INSTALL REAR ABSORBER CAP
  1. Engage the 2 guides and 2 claws to install the rear absorber cap.



5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



6. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



7. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
  1. Fully tighten the rear shock absorber assembly (lower side) with the bolt.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

    NOTICE:
    Since a stopper nut is used, turn the bolt.



8. INSPECT REAR WHEEL ALIGNMENT
(Click here)