REAR COIL SPRING > INSTALLATION |
| 1. INSTALL REAR LOWER COIL SPRING INSULATOR LH |
Install the rear lower coil spring insulator LH onto the rear axle beam assembly.
| 2. INSTALL REAR LOWER COIL SPRING INSULATOR RH |
| 3. INSTALL REAR UPPER COIL SPRING INSULATOR LH |
![]() |
Install the rear upper coil spring insulator LH so that its gap fits onto the end of rear coil spring LH.
| *a | Fit |
| 4. INSTALL REAR UPPER COIL SPRING INSULATOR RH |
| 5. INSTALL REAR COIL SPRING LH |
Support the spring seat of the rear axle beam assembly using 2 jacks and 2 wooden blocks.
Remove the 2 bolts while holding the 2 nuts and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Slowly lower the rear axle beam assembly using 2 jacks and 2 wooden blocks.
![]() |
Install the rear coil spring LH onto the rear axle beam assembly.
![]() | Paint Mark |
Slowly jack up the rear axle beam assembly using 2 jacks and 2 wooden blocks, and temporarily install the rear axle beam assembly and rear coil spring LH with the 2 bolts and 2 nuts.
| 6. INSTALL REAR COIL SPRING RH |
| 7. INSTALL REAR FLEXIBLE HOSE LH |
Install the rear flexible hose LH onto the rear axle beam assembly with a new clip.
Using a union nut wrench, install the rear flexible hose LH to the brake tube while holding the rear flexible hose LH with a wrench.
| 8. INSTALL REAR FLEXIBLE HOSE RH |
| 9. INSTALL SKID CONTROL SENSOR WIRE LH |
Install the skid control sensor wire LH to the rear axle beam assembly with the nut.
| 10. INSTALL SKID CONTROL SENSOR WIRE RH |
| 11. CONNECT SKID CONTROL SENSOR WIRE LH |
![]() |
Install the skid control sensor wire connector to the connector cover.
![]() |
Engage the 3 claws to secure the connector cover.
Connect the skid control sensor wire connector to the rear axle hub and bearing assembly.
| 12. CONNECT SKID CONTROL SENSOR WIRE RH |
| 13. INSTALL REAR WHEEL |
| 14. STABILIZE SUSPENSION |
Lower the vehicle from the jack.
Bounce the vehicle up and down several times to stabilize the suspension.
| 15. FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY |
![]() |
Suspend the jack on the spring seat of the rear axle beam assembly and adjust the length of the rear shock absorber assembly to the reference value.
| *A | LH Side |
| *B | RH Side |
Fully tighten the 2 bolts.
| 16. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH |
Fully tighten the rear shock absorber assembly (lower side) with the bolt.
| 17. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH |
| 18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 19. BLEED BRAKE LINE |
| 20. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor) |
| 21. INSPECT REAR WHEEL ALIGNMENT |
| 22. CHECK SPEED SENSOR SIGNAL |