Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1552/52    DC Motor Power Source Voltage Malfunction

DTC    C1554/54    EPS Relay Circuit

for Preparation Click here


DESCRIPTION

When a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1552/52
PIG power source circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU assembly
C1554/54
Power source relay circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU assembly

WIRING DIAGRAM


C246150E05


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and the torque sensor zero point calibration (Click here).

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING INTELLIGENT TESTER
  1. Turn the power switch off (lock).

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (ready).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "PIG power supply" in the Data List and read the value displayed on the intelligent tester.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PIG Power Supply
    Power source voltage to activate motor/
    Min.: 0.0000 V
    Max.: 20.1531 V
    9 to 16 V
    Always

    OK:
    The normal condition value is displayed on the intelligent tester.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS 

2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - POWER STEERING ECU ASSEMBLY - BODY GROUND)


    C250086E02
  1. Disconnect the connector from the power steering ECU assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A33-1 (PIG) - Body ground
    Always
    9 to 16 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A33-2 (PGND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Power Steering ECU Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)