ECM > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE ECM (for RHD) |
![]() |
Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.
![]() |
Remove the bolt and nut.
Remove the ECM.
![]() |
Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.
| 5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD) |
| 6. REMOVE INNER COWL TOP TO COWL BRACE (for LHD) |
![]() |
Remove the 3 bolts and inner cowl top to cowl brace.
| 7. REMOVE FRONT AIR SHUTTER SEAL (for LHD) |
![]() |
Disengage the clamp to remove the front air shutter seal.
| 8. REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD) |
![]() |
Disengage the clamp to remove the front No. 1 ventilator seal.
| 9. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD) |
![]() |
Disengage the clamp to separate the wire harness from the outer cowl top panel sub-assembly.
![]() |
Remove the 8 bolts, nut and outer cowl top panel sub-assembly.
| 10. REMOVE ECM (for LHD) |
![]() |
Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.
![]() |
Remove the bolt and nut.
Remove the ECM.
![]() |
Remove the nut.
![]() |
Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.